The "UEFI Defaults have been loaded. Press F2 or DEL to Run Setup. Press F1 to Continue" message is the result of an error usually due to a power surge or the improper shutdown of a Unit.
Instructions:
1. Press the F1 key on your remote.
If your remote does not have this key, locate a corded keyboard (not a bluetooth keyboard) and plug the USB into an available slot on the side of your TRAZER Unit. Click the F1 key on the keyboard.
To prevent this issue, it is best to always shutdown the TRAZER Unit completely (using the Unit's power button) before unplugging the Unit from its power source. It is also recommended to use a surge protector on the outlet or extension cord the Unit is plugged into, especially when taking TRAZER out of your facility.